PDA

View Full Version : Downrigger for Pontoon boat



RickM
01-19-2012, 09:06 PM
I have a pontoon boat (22ft) that I would like to add downriggers on for Kokanee fishing. Has anyone done that and looking for suggestions. thanks

Calcan
01-19-2012, 09:41 PM
I had a 20 foot pontoon and mounted two scottys on 13 in. seat bases, I also cut a hole in the middle of the floor and put a 50 thrust minn kota just ahead of the main motor I could control it from the drivers seat and use the main motor for a rudder. I sure do miss that boat. I hope that helps

RalphL
01-19-2012, 11:00 PM
I have a pontoon boat (22ft) that I would like to add downriggers on for Kokanee fishing. Has anyone done that and looking for suggestions. thanks

let me dig out thi pics of my dr mod and get them posted..

lowe1648mt
01-20-2012, 10:02 AM
From the stand point of steering in a wind, I would mount the trolling motor on the bow. It will have to be off center, as you don't want to hit the winch stand on the trailer.You can't push a rope, but you can pull it. Want to make it easy, get a remote control electric bow mount motor. They even make remote control bow mount anchors.

SuperD
01-20-2012, 11:18 AM
depending on how big of downriggers you plan on mounting, the V-Lock mounts have been rock solid on everything I've used them on. Here is a rail mount application if you have rail in locations where you would like downriggers.

http://store.v-lock.com/collections/v-lock-products/products/square-rail-mount-kit

TrollNFisher
01-22-2012, 12:46 PM
These pictures are off my boat in Texas and I found a couple of photo’s of how me and a buddy came up with mounting riggers on a old pontoon boat, we mounted four cannons on the boat with swivel bases. We used treated 2x6’s and used galvanized piping to stabilize it and mounted to the floor I don’t have photo’s of the pipe mounts though. This was a pontoon that had all the couches and stuff by they were gutted off and this was converted into a strictly fishing rig which we trolled for Hybrids and Stripers. These were the best photo's I could find showing the setup, Hope this helps.

platypus
01-22-2012, 02:14 PM
--Scotties and others have rail mount kit... this would allow you to move position if you don't like original. Some universal style allow substitution of rod holders etc. to same mounting kit

redmanjr1
02-13-2012, 11:26 PM
This is what I did to my boat...works very well for us. Hope it gives you an idea for your boat's configuration. My posts/pics are toward the bottom of the first page of the below link.

Thanks,
Bob

http://www.kokaneefishingforum.com/fishing-forums/showthread.php?t=3275

RalphL
02-14-2012, 10:21 AM
Here are some pics of the downrigger mount on the modified fishing platform off the stern, as well as a couple of the Powr Tran Toon Kicker bracket. These are the best I've got until I uncover the boat and get some tighter pictures, but they should give you an idea.

3388

3389

3390

3391

redmanjr1
02-15-2012, 10:23 PM
I wondered how you would mount a kicker to a toon. That is awesome. Making me think I may be spending some more money on that boat...doh!

RalphL
02-16-2012, 12:22 AM
tie the two motors together with an EZ Steer and steer from the main wheel